Cisco 300-115 PDF Study Guide – Examguideview

As a professional IT exam study material provider, examguideview.com gives you more than just exam questions and answers. We provide our customers with the most accurate study material about 300-115 exam and 100% guarantee of pass. We assist you to prepare for almost all the 300-115 certifications which are regarded valuable the IT sector. You can easily find 300-115 exam dumps on our answers are very easy to understand.

Latest 300-115 pdf study guide questions and answers (12Q&As)

QUESTION 1
Exhibit:
A network administrator is troubleshooting an EIGRP connection between RouterA, IP address 10.1.2.1, and RouterB, IP address 10.1.2.2. Given the debug output on RouterA, which two statements are true? (Choose two.)
A. RouterA received a hello packet with mismatched autonomous system numbers.
B. RouterA received a hello packet with mismatched hello timers.
C. RouterA received a hello packet with mismatched authentication parameters.
D. RouterA received a hello packet with mismatched metric-calculation mechanisms.
E. RouterA will form an adjacency with RouterB.
F. RouterA will not form an adjacency with RouterB.
300-135 exam Correct Answer: DF Explanation
Explanation/Reference:

QUESTION 2
When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful. What is the next thing that should be checked?
A. Verify that the EIGRP hello and hold timers match exactly.
B. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.
C. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.
D. Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.
300-115 PDF Correct Answer: D Explanation
Explanation/Reference:

QUESTION 3
Refer to the exhibit.
How would you confirm on R1 300-135  dumps that load balancing is actually occurring on the default-network (0.0.0.0)?
A. Use ping and the show ip route command to confirm the timers for each default network resets to 0.
B. Load balancing does not occur over default networks; the second route will only be used for failover.
C. Use an extended ping along with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.
D. Use the traceroute command to an address that is not explicitly in the routing table.
Correct Answer: D Explanation
Explanation/Reference:

QUESTION 4
– (Topic 15)
The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client
1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network
addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and
device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241
address. Use the supported commands to isolated the cause of this fault and answer the following questions.
The fault condition is related to which technology?
A. Under the global configuration mode enter no access-list 10 command.
B. Under the global configuration mode enter no access-map vlan 10 command.
C. Under the global configuration mode enter no vlan access-map test1 10 command.
D. Under the global configuration mode enter no vlan filter test1 vlan-list 10 command.
300-115 pdf Correct Answer: C

Question: 5
Which is a valid technique for preventing unauthorized users from triggering a process flow?
A. lock down all process flows using transport specific security mechanisms
B. lock down the Starter activity at the transport level via transport specific security
C. supply a User ID and password when logging into a BusinessWorks Process Engine
D. prevent each BusinessWorks process flow from unauthorized access by assigning a role to it
300-115 pdf Answer: B

Question: 6
Your organization has created a standard for organizing TIBCO BusinessWorks projects. Which
is most suited to this task?
A. TIBCO Adapters
B. TIBCO PortalBuilder
C. TIBCO Domain Utility
D. TIBCO Designer templates
Answer: D

Question: 7
Which two messaging protocols can be used to communicate between a BusinessWorks process
and a TIBCO Adapter? (Choose two.)
A. SOAP
B. RosettaNet
C. Rendezvous
D. Message Queues
E. Java Message Service
300-115 pdf Answer: C, E

Question: 8
Which statement is true about JRE requirements for installing TIBCO BusinessWorks
components?
A. A JRE must be installed prior to installing TIBCO BusinessWorks components.
B. No JRE is needed or used during the installation of TIBCO BusinessWorks components.
C. All installed JREs must be uninstalled prior to installing TIBCO BusinessWorks components.
D. All TIBCO BusinessWorks component installers can use a preinstalled JRE or its own
embedded JVM.
Answer: D

QUESTION 9
A property is a feature that can be represented in what ways? (Choose two)
A. as an association
B. as an association end
C. as an attribute in a class
D. as an operation in a class
E. as an indication of whether the feature is public or private
300-115 exam Correct Answer: BC

QUESTION 10
What does it mean when a classifier rectangle is labeled as an <<eration>>?
A. The list of all public and private features is provided.
B. The classifier is an iterator for traversing a collection.
C. The list of all public and private structural features is suppressed.
D. The classifier is a data type whose values are possibly listed in the bottom compartment.
Correct Answer: D

QUESTION 11
What are some of the important semantics of packages? (Choose three)
A. A class may be owned by multiple packages.
B. An element may be owned by at most one package.
C. The public contents of a package are accessible outside the package.
D. The public contents of a package are not accessible outside the package.
E. If a package is removed from a model, the owned contents are removed.
F. If a package is removed from a model, the owned contents are reassigned.
300-115 pdf Correct Answer: BCE

QUESTION 12
What does the arrow end of a dependency relationship indicate?
A. more general classifier
B. element initiates communication
C. whole in a whole-part relationship
D. client element is affected by a change in the supplier element
E. supplier element is unaffected by a change in the client element
Correct Answer: E

So that you can get the latest 300-115 exam information in time. We will be use the greatest efficiency to service each candidate. Everyone has their own life planning. Different selects will have different acquisition. So the http://www.bestexampass.com/300-115.html dumps choice is important.